We are using TCAN1145-Q1 to judge it is wake up frame from the network or not by CANINT register bit. While we found when there are other nodes receiving WUF, this TCAN1145 node cannot assert register ...

Reg63 ”DAC Channel Volume Control's Soft-Step control”...Soft-Stepping is 1 step per 1 or 2 DAC Word Clock I would like to check whether there is any pop noise when switching from maximum volume to ...

I met the similar problem when using ads1274EVM-PDK, And of course, the USB device was enumenated under NI-VISA USB Devices: My PC is Windows 10 64 bit. In C:\Program Files (x86)\ADCPro\drivers ...

I am looking for software help on a CAN interface that is on the TI CP3UB26 microcontroller as well as on the NatSemi/TI CR16 family. Does TI have any software drivers for this CAN peripheral? Thank ...

If the customer is using bandgap reference, I would suggest to follow the table below. REF35, REF34 are reasonable cost. Depending on your accuracy requirements over temperature, REF35 or equivalent ...

I'm using CC2340R5-Q1 MCU and SDK simplelink_lowpower_f3_sdk_8_10_01_02. I use the basic_ble project and integrate i2ctarget into it. If I2C receives I2C data, it ...

We use gmake tool to build our AM62Ax project in windows operation system, sometimes the compiler report error log as the screenshot show,but if we try to rebuild the ...

I want to use Z-Stack on CC2538. Most of the QnA on this forum mentions that Z-Stack 3.0.2 cannot be used on CCS for CC2538, and one needs to use IAR for the development. CCS does not support CC2538 ...

Here is what we want to achieve when evaluate on TI EVM. We have an application running on Linux A53 core and we want to update it each time we power on the EVM. Using EMMC boot media of EVM, after ...

we use the LM5164 chip on many electronic boards and we are very satisfied. I noticed that typically the impedance of the VIN pin (referred to the GND pin) is around 9MΩ. The measurement is made with ...

Hello, my device is of HSSE type. R5 was previously developed under version mcu_plus_sdk_am62x_08_06_00_18. The compiled firmware will finally be signed by the ...

does someone has an example for an U-Boot "sspi" command to communicate with an OSPI NOR flash? I would like to read some status information from the XSPI/OSPI NOR flash used for booting on my board ...